Refer to the exhibit.



Switch - 1 and Switch - 2 ate ArubaOS - CX switches that implement VXLAN WITHOUT Ethernet VPN (EVPN). Switch - 2 uses the same VNI - to - VLAN mappings as Switch - 1. Is this how the specified servers communicate? Solution: The first time that Server I communicates with Server 3, It sends an ARP request to resolve Server 3's MAC address.

You want to use NetEdit to configure an AtubaOS - CX switch. Is this a minimum requirement for setting up communications between the switch and NetEdit? Solution: Enable the REST interface in read - only mode.

You want to use NetEdit to configure an AtubaOS - CX switch. Is this a minimum requirement for setting up communications between the switch and NetEdit? Solution: Make sure that the SSH server is enabled.

Is this a guideline for establishing a Virtual Switching Extension (V5X) Inter - Switch Link (ISL) between two ArubaOS - CX switches? Solution: Use the same speed on every link In the ISL.

Refer to the exhibit. Refer to the exhibit.



You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch - 1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B. Is this part of a valid setup for meeting these requirements? Solution: Add VRF B as the secondary VRF on VLAN interface 30.