Question No 1

Refer to the partial exhibit from an HPE Aruba Networking CX 8325:

A new port 1/1/44 needs to be configured to connect to a 29301, which has the following configuration:

Which configuration would be used?

A.

B.

C.

D.

Choose the Choices:

Question No 2

OSPF peering is configured between HPE Aruba Networking CX 6300 switches utilizing BFD. You've made this configuration on switch B, while switch A is in the default configuration:

Which BFD Tx/Rx interval values will switch A use for the show bfd session?

Choose the Choices:

Question No 3

You have applied the following OSPF configuration but are seeing the output from the command below. What is the reason for this?

Choose the Choices:

A loopback interface hasn't been configured on Agg - 2

OSPF interfaces are passive by default

A different OSPF process ID is used on each switch

A Layer - 3 interface has not been associated with a VRF

Question No 4

You need to run a packet capture on a CX switch and be able to view the full output on a remote device in real - time. What is the best way to do this?

Choose the Choices:

Configure a mirror session using ERSPAN to a computer running Wireshark

Inspect the summary of the packets in real time on the switch using tcpdump

Configure a mirror session with another port on the switch as the destination

Configure a mirror session to the CPU, use tshark to capture it to a PCAP file

Question No 5

When configuring a multicast solution on HPE Aruba Networking CX switches, what needs to be configured on the access switch to enable efficient traffic flow?

Choose the Choices:

Practice HP HPE7-A08 Exam Questions

Question No 1

Question No 2

Question No 3

Question No 4

Question No 5

HPE7-A08 Exam Features

HPE7-A08 PDF Dumps